Forum

How to simulate abaqus 3D model using swiftcomp?

  1. Nagappa Siddgonde

    Dear sir i have created some complex 3D geometrical model  so that i have to verify the results of same model using swiftcomp (MSG).  initially i  have created my 3D model into .sc file through Abaqus GUI-swiftcomp. after that i imported .sc file &run through Swiftcom but i am not getting any results....only generated empty  .sc.k file. can anyone suggest me how to simulate abaqus model using  SwiftComp tool

  2. Bo Peng

    Hi Nagappa,

    As you can see in the picture attached, the element quality was not good enough and resulted in negative Jocobian. You may try to mesh it better. If this cannot solve your problem, another recommendation is to change your geometry unit, for example from 'm' to 'mm', which means to scale you geometry part by a 1000 times. 

    Capture.PNG

  3. Hamdi Mawloud

    Hi, I am using Abaqus_SwiftComp_GUI (3D orthogonal textile plate), I get the message: Error from factor and solve of sparse solver with info%flag=-38
    Please help me. Thank you

  4. Wenbin Yu

    Can you share the *.sc file with us? ---- Emailed forum response from wenbinyu@purdue.edu