Resources: All

Find a resource
  1. compositesmanufacturing x
  2. compositesanalysis x
  1. Injection Overmolding Manufacturing Process Simulation

    29 Jun 2017 | Online Presentations

    Injection over-molding or hybrid molding is a high-rate composites manufacturing process for fabrication of structural components with complex geometries.  The structural backbone is provided by a continuous-fiber woven prepreg while the geometric complexity is realized via injection...

  2. 2015 cdmHUB Workshop

    05 Jan 2016 | Series

    Composites Design, Analysis and Manufacturing Workshop held at Purdue University on November 3-5, 2015.  Both lectures slides and lecture videos are presented.

  3. 2015 cdmHUB Workshop

    05 Jan 2016 | Series

    Composites Design, Analysis and Manufacturing Workshop held at Purdue University on November 3-5, 2015.  Both lectures slides and lecture videos are presented.

  4. NAFEMS Invitation to Tender: How to Obtain Material Properties for Structural Analysis of Composites

    13 Feb 2015 | White Papers/Research Documents

    The NAFEMS Composites Working Group wishes to commission a new document with the suggested title "How to Obtain Material Properties for Structural Analysis of Composites". The book will be a companion volume to the existing NAFEMS publications "An introduction to the use of material models in...

  5. DiBenedetto Equation: Tg and DOC

    23 Jul 2014 | Tools

    DiBenedetto Equation: Glass Transition Temperature Dependence on Degree of Cure

  6. The Mission, Vision and Programs of the Composites Design and Manufacturing HUB

    23 Jul 2014 | Teaching Materials

    The presentation outlines the mission, vision and programs of the Composites Design and Manufacturing HUB as of October 2014.

  7. Composite Materials and Structures 1972-2012: Grand Challenges

    23 Jul 2014 | Teaching Materials

    Professor R. Byron Pipes presents the Grand Challenges for Composite Materials for the next 40 years at the American Society of Composites Conference in Arlington, TX on October 2, 2012.

  8. 2013 Composites Design and Manufacturing HUB Kickoff Workshop

    23 Jul 2014 | Series

    The Composites Design and Manufacturing HUB held a kick-off workshop at Purdue University on May 29-30, 2013 with over 100 attendees from industry, academia and government.  Select presentations from the workshop are included in this series.