-
2013 Composites Design and Manufacturing HUB Kickoff Workshop
04 Sep 2014 | Series | Contributor(s): SME Project
The Composites Design and Manufacturing HUB held a kick-off workshop at Purdue University on May 29-30, 2013 with over 100 attendees from industry, academia and government. Select presentations from the workshop are included in this series.
-
2015 cdmHUB Workshop
05 Jan 2016 | Series
Composites Design, Analysis and Manufacturing Workshop held at Purdue University on November 3-5, 2015. Both lectures slides and lecture videos are presented.
-
Anousch Poursartip UBC CDM Hub
15 Feb 2019 | Online Presentations | Contributor(s): SME Project
-
CDM HUB Breakout Sessions
15 Feb 2019 | Online Presentations | Contributor(s): SME Project
Breakout sessions from the May 2013 Composites Design and Manufacturing HUB workshop
-
CDM Hub Breakout Sessions 1 and 2 B-Roll
15 Feb 2019 | Online Presentations | Contributor(s): SME Project
-
CDM Hub Breakout Sessions Introduction
15 Feb 2019 | Online Presentations | Contributor(s): SME Project
-
CDM Hub Introduction
17 Mar 2015 | Online Presentations | Contributor(s): SME Project
-
Chuck Tucker UIUC CDM Hub
15 Feb 2019 | Online Presentations | Contributor(s): SME Project
-
Composite Materials and Structures 1972-2012: Grand Challenges
19 Sep 2014 | Teaching Materials
Professor R. Byron Pipes presents the Grand Challenges for Composite Materials for the next 40 years at the American Society of Composites Conference in Arlington, TX on October 2, 2012.
-
DiBenedetto Equation: Tg and DOC
23 Jul 2014 | Tools
DiBenedetto Equation: Glass Transition Temperature Dependence on Degree of Cure
-
Gillespie CCM
21 Aug 2024 | Online Presentations | Contributor(s): SME Project
Presentation at the May 2013 Composites Design and Manufacturing HUB workshop
-
Greg Schoeppner CDM Hub
21 Aug 2024 | Online Presentations | Contributor(s): SME Project
-
Hubert McGill
21 Aug 2024 | Online Presentations | Contributor(s): SME Project
Presentation at the May 2013 Composites Design and Manufacturing HUB workshop
-
Injection Overmolding Manufacturing Process Simulation
23 Jul 2014 | Online Presentations
Injection over-molding or hybrid molding is a high-rate composites manufacturing process for fabrication of structural components with complex geometries. The structural backbone is provided by a continuous-fiber woven prepreg while the geometric complexity is realized via injection...
-
Jack Gillespie CDM Hub
21 Aug 2024 | Online Presentations | Contributor(s): SME Project
-
Jacob Fish Columbia CDM Hub
21 Aug 2024 | Online Presentations | Contributor(s): SME Project
-
Jerry Young Boeing CDM Hub
21 Aug 2024 | Online Presentations | Contributor(s): SME Project
-
Nanohub and the HUBzero Platform
21 Aug 2024 | Online Presentations | Contributor(s): SME Project
Dr. Michael McLennan describes the nanoHUB and HUBzero platform at the May 2013 Composites Design and Manufacturing HUB workshop.
-
Ove Schuett Dassault Systemes Americas CDM Hub
21 Aug 2024 | Online Presentations | Contributor(s): SME Project
-
Pascal Hubert CDM Hub
21 Aug 2024 | Online Presentations | Contributor(s): SME Project