-
2013 Composites Design and Manufacturing HUB Kickoff Workshop
04 Sep 2014 | Series | Contributor(s): SME Project
The Composites Design and Manufacturing HUB held a kick-off workshop at Purdue University on May 29-30, 2013 with over 100 attendees from industry, academia and government. Select presentations from the workshop are included in this series.
-
2015 cdmHUB Workshop
05 Jan 2016 | Series
Composites Design, Analysis and Manufacturing Workshop held at Purdue University on November 3-5, 2015. Both lectures slides and lecture videos are presented.
-
2015 cdmHUB Workshop
05 Jan 2016 | Series
Composites Design, Analysis and Manufacturing Workshop held at Purdue University on November 3-5, 2015. Both lectures slides and lecture videos are presented.
-
Anousch Poursartip UBC CDM Hub
15 Feb 2019 | Online Presentations | Contributor(s): SME Project
-
CDM HUB Breakout Sessions
15 Feb 2019 | Online Presentations | Contributor(s): SME Project
Breakout sessions from the May 2013 Composites Design and Manufacturing HUB workshop
-
CDM Hub Breakout Sessions 1 and 2 B-Roll
15 Feb 2019 | Online Presentations | Contributor(s): SME Project
-
CDM Hub Breakout Sessions Introduction
15 Feb 2019 | Online Presentations | Contributor(s): SME Project
-
CDM Hub Introduction
17 Mar 2015 | Online Presentations | Contributor(s): SME Project
-
Chuck Tucker UIUC CDM Hub
15 Feb 2019 | Online Presentations | Contributor(s): SME Project
-
Composite Materials and Structures 1972-2012: Grand Challenges
19 Sep 2014 | Teaching Materials
Professor R. Byron Pipes presents the Grand Challenges for Composite Materials for the next 40 years at the American Society of Composites Conference in Arlington, TX on October 2, 2012.
-
Constitutive modeling for time- and temperature-dependent behavior of composites
08 Jan 2020 | Publications
Structural integrity, durability, and thermal stability represent critical areas for adequately modeling the behavior of composite materials. Polymeric matrices are prone to have time-dependent behavior very sensitive to changes in temperature that influence the effective properties of the...
-
DiBenedetto Equation: Tg and DOC
23 Jul 2014 | Tools
DiBenedetto Equation: Glass Transition Temperature Dependence on Degree of Cure
-
Effective Lamina and Laminate Properties
14 Feb 2014 | Tools
Calculate effective lamina and laminate properties from phase properties and layup.
-
Gillespie CCM
17 Aug 2024 | Online Presentations | Contributor(s): SME Project
Presentation at the May 2013 Composites Design and Manufacturing HUB workshop
-
Greg Schoeppner CDM Hub
17 Aug 2024 | Online Presentations | Contributor(s): SME Project
-
Halpin-Tsai Micromechanics Model
14 Feb 2014 | Tools
Calculate homogenized lamina properties from fiber and matrix properties
-
Hubert McGill
17 Aug 2024 | Online Presentations | Contributor(s): SME Project
Presentation at the May 2013 Composites Design and Manufacturing HUB workshop
-
Injection Overmolding Manufacturing Process Simulation
23 Jul 2014 | Online Presentations
Injection over-molding or hybrid molding is a high-rate composites manufacturing process for fabrication of structural components with complex geometries. The structural backbone is provided by a continuous-fiber woven prepreg while the geometric complexity is realized via injection...
-
Jack Gillespie CDM Hub
17 Aug 2024 | Online Presentations | Contributor(s): SME Project
-
Jacob Fish Columbia CDM Hub
17 Aug 2024 | Online Presentations | Contributor(s): SME Project