-
Orthotropic Stress Concentration Factor
25 Sep 2014 | Tools
Calculates the stress concentration factor for a circular hole in an infinite orthotropic plate
-
2015 cdmHUB Workshop
23 Jul 2014 | Series
Composites Design, Analysis and Manufacturing Workshop held at Purdue University on November 3-5, 2015. Both lectures slides and lecture videos are presented.
-
CDM Hub Introduction
22 Oct 2024 | Online Presentations | Contributor(s): SME Project
-
NAFEMS Invitation to Tender: How to Obtain Material Properties for Structural Analysis of Composites
23 Jul 2014 | White Papers/Research Documents
The NAFEMS Composites Working Group wishes to commission a new document with the suggested title "How to Obtain Material Properties for Structural Analysis of Composites". The book will be a companion volume to the existing NAFEMS publications "An introduction to the use of material models in...
-
The Mission, Vision and Programs of the Composites Design and Manufacturing HUB
22 Oct 2024 | Teaching Materials | Contributor(s): SME Project
The presentation outlines the mission, vision and programs of the Composites Design and Manufacturing HUB as of October 2014.
-
The Mission, Vision and Programs of the Composites Design and Manufacturing HUB
25 Sep 2014 | Teaching Materials
The presentation outlines the mission, vision and programs of the Composites Design and Manufacturing HUB as of October 2014.
-
Plane-Stress Compliance Transform
25 Sep 2014 | Tools
Transforms 2D compliance terms by rotation about the 3-axis
-
2013 Composites Design and Manufacturing HUB Kickoff Workshop
22 Oct 2024 | Series | Contributor(s): SME Project
The Composites Design and Manufacturing HUB held a kick-off workshop at Purdue University on May 29-30, 2013 with over 100 attendees from industry, academia and government. Select presentations from the workshop are included in this series.
-
2013 Composites Design and Manufacturing HUB Kickoff Workshop
23 Jul 2014 | Series
The Composites Design and Manufacturing HUB held a kick-off workshop at Purdue University on May 29-30, 2013 with over 100 attendees from industry, academia and government. Select presentations from the workshop are included in this series.
-
Nanohub and the HUBzero Platform
22 Oct 2024 | Online Presentations | Contributor(s): SME Project
Dr. Michael McLennan describes the nanoHUB and HUBzero platform at the May 2013 Composites Design and Manufacturing HUB workshop.
-
The Challenge and Vision for cdmHUB
22 Oct 2024 | Online Presentations | Contributor(s): SME Project
Professor R. Byron Pipes presents the challenge and vision for the cdmHUB at the May 2013 Composites Design and Manufacturing HUB workshop