-
Orthotropic Stress Concentration Factor
25 Sep 2014 | Tools
Calculates the stress concentration factor for a circular hole in an infinite orthotropic plate
-
2015 cdmHUB Workshop
27 Jun 2014 | Series | Contributor(s): Nikki Huang
Composites Design, Analysis and Manufacturing Workshop held at Purdue University on November 3-5, 2015. Both lectures slides and lecture videos are presented.
-
HyperSizer for Composites: Insanely Fast Laminate Optimization
27 Jun 2014 | Tool Information | Contributor(s): Nikki Huang
95% of users, without user manual, and without instruction, will be able to import their FEM and produce optimum composites laminates that satisfy all analyses to all load cases within the first 10 minutes. Your automatically updated model will have minimum weight and fully producible laminates...
-
CDM Hub Introduction
16 Aug 2024 | Online Presentations | Contributor(s): SME Project
-
The Mission, Vision and Programs of the Composites Design and Manufacturing HUB
16 Aug 2024 | Teaching Materials | Contributor(s): SME Project
The presentation outlines the mission, vision and programs of the Composites Design and Manufacturing HUB as of October 2014.
-
The Mission, Vision and Programs of the Composites Design and Manufacturing HUB
25 Sep 2014 | Teaching Materials
The presentation outlines the mission, vision and programs of the Composites Design and Manufacturing HUB as of October 2014.
-
Plane-Stress Compliance Transform
25 Sep 2014 | Tools
Transforms 2D compliance terms by rotation about the 3-axis
-
2013 Composites Design and Manufacturing HUB Kickoff Workshop
27 Jun 2014 | Series | Contributor(s): Nikki Huang
The Composites Design and Manufacturing HUB held a kick-off workshop at Purdue University on May 29-30, 2013 with over 100 attendees from industry, academia and government. Select presentations from the workshop are included in this series.
-
2013 Composites Design and Manufacturing HUB Kickoff Workshop
16 Aug 2024 | Series | Contributor(s): SME Project
The Composites Design and Manufacturing HUB held a kick-off workshop at Purdue University on May 29-30, 2013 with over 100 attendees from industry, academia and government. Select presentations from the workshop are included in this series.
-
HyperSizer Pro Software from Collier Research
27 Jun 2014 | Tool Information | Contributor(s): Nikki Huang
HyperSizer® is Design, Analysis, and Optimization Software for Composite and Metallic Structures HyperSizer is used throughout the design process--including certification--to quantify all critical failure modes, reduce structural weight, and sequence composite laminates for fabrication to...
-
Nanohub and the HUBzero Platform
16 Aug 2024 | Online Presentations | Contributor(s): SME Project
Dr. Michael McLennan describes the nanoHUB and HUBzero platform at the May 2013 Composites Design and Manufacturing HUB workshop.
-
The Challenge and Vision for cdmHUB
16 Aug 2024 | Online Presentations | Contributor(s): SME Project
Professor R. Byron Pipes presents the challenge and vision for the cdmHUB at the May 2013 Composites Design and Manufacturing HUB workshop