-
Pascal Hubert CDM Hub
15 Feb 2019 | Contributor(s): SME Project
-
The Challenge and Vision for cdmHUB
15 Feb 2019 | Online Presentations | Contributor(s): SME Project
-
VABS: Powering Simple Beam Elements with Detailed 3D FEA Fidelity
06 Jan 2017 | Downloads
This presentation gives a brief introduction to VABS, a general-purpose cross-sectional analysis, which can power conventional, simple beam elements with detailed 3D FEA fidelity.
-
Orthotropic Stress Concentration Factor
25 Sep 2014 | Tools
Calculates the stress concentration factor for a circular hole in an infinite orthotropic plate
-
CDM Hub Introduction
21 Oct 2024 | Online Presentations | Contributor(s): SME Project
-
The Mission, Vision and Programs of the Composites Design and Manufacturing HUB
21 Oct 2024 | Teaching Materials | Contributor(s): SME Project
The presentation outlines the mission, vision and programs of the Composites Design and Manufacturing HUB as of October 2014.
-
The Mission, Vision and Programs of the Composites Design and Manufacturing HUB
25 Sep 2014 | Teaching Materials
The presentation outlines the mission, vision and programs of the Composites Design and Manufacturing HUB as of October 2014.
-
Plane-Stress Compliance Transform
25 Sep 2014 | Tools
Transforms 2D compliance terms by rotation about the 3-axis
-
2013 Composites Design and Manufacturing HUB Kickoff Workshop
21 Oct 2024 | Series | Contributor(s): SME Project
The Composites Design and Manufacturing HUB held a kick-off workshop at Purdue University on May 29-30, 2013 with over 100 attendees from industry, academia and government. Select presentations from the workshop are included in this series.
-
Nanohub and the HUBzero Platform
21 Oct 2024 | Online Presentations | Contributor(s): SME Project
Dr. Michael McLennan describes the nanoHUB and HUBzero platform at the May 2013 Composites Design and Manufacturing HUB workshop.
-
The Challenge and Vision for cdmHUB
21 Oct 2024 | Online Presentations | Contributor(s): SME Project
Professor R. Byron Pipes presents the challenge and vision for the cdmHUB at the May 2013 Composites Design and Manufacturing HUB workshop