Resources: All

Submit a resource

Find a resource
  1. compositesmanufacturing x
  2. prepregplateletcomposites x
  3. cdmhub x

  1. Pascal Hubert CDM Hub

    0.0 out of 5 stars 

    15 Feb 2019 | Contributor(s): SME Project

  2. The Challenge and Vision for cdmHUB

    0.0 out of 5 stars 

    15 Feb 2019 | Online Presentations | Contributor(s): SME Project

  3. Injection Overmolding Manufacturing Process Simulation

    0.0 out of 5 stars 

    29 Jun 2017 | Online Presentations

    Injection over-molding or hybrid molding is a high-rate composites manufacturing process for fabrication of structural components with complex geometries.  The structural backbone is provided by a continuous-fiber woven prepreg while the geometric complexity is realized via injection...

  4. 2015 cdmHUB Workshop

    0.0 out of 5 stars 

    05 Jan 2016 | Series

    Composites Design, Analysis and Manufacturing Workshop held at Purdue University on November 3-5, 2015.  Both lectures slides and lecture videos are presented.

  5. CDM Hub Introduction

    0.0 out of 5 stars 

    17 Mar 2015 | Online Presentations | Contributor(s): SME Project

  6. DiBenedetto Equation: Tg and DOC

    0.0 out of 5 stars 

    23 Jul 2014 | Tools

    DiBenedetto Equation: Glass Transition Temperature Dependence on Degree of Cure

  7. The Mission, Vision and Programs of the Composites Design and Manufacturing HUB

    0.0 out of 5 stars 

    18 May 2024 | Teaching Materials | Contributor(s): SME Project

    The presentation outlines the mission, vision and programs of the Composites Design and Manufacturing HUB as of October 2014.

  8. The Mission, Vision and Programs of the Composites Design and Manufacturing HUB

    0.0 out of 5 stars 

    23 Jul 2014 | Teaching Materials

    The presentation outlines the mission, vision and programs of the Composites Design and Manufacturing HUB as of October 2014.

  9. Composite Materials and Structures 1972-2012: Grand Challenges

    0.0 out of 5 stars 

    23 Jul 2014 | Teaching Materials

    Professor R. Byron Pipes presents the Grand Challenges for Composite Materials for the next 40 years at the American Society of Composites Conference in Arlington, TX on October 2, 2012.

  10. 2013 Composites Design and Manufacturing HUB Kickoff Workshop

    0.0 out of 5 stars 

    18 May 2024 | Series | Contributor(s): SME Project

    The Composites Design and Manufacturing HUB held a kick-off workshop at Purdue University on May 29-30, 2013 with over 100 attendees from industry, academia and government.  Select presentations from the workshop are included in this series.

  11. Nanohub and the HUBzero Platform

    0.0 out of 5 stars 

    18 May 2024 | Online Presentations | Contributor(s): SME Project

    Dr. Michael McLennan describes the nanoHUB and HUBzero platform at the May 2013 Composites Design and Manufacturing HUB workshop.

  12. The Challenge and Vision for cdmHUB

    0.0 out of 5 stars 

    18 May 2024 | Online Presentations | Contributor(s): SME Project

    Professor R. Byron Pipes presents the challenge and vision for the cdmHUB at the May 2013 Composites Design and Manufacturing HUB workshop