The example I'm trying is 'x1_uh60_sopt_stf' which is created after installing iVABS.
An error message appears as shown in the attached picture.
It is assumed that the error occurs because VABS cannot be started because the first line, ln_af, is not drawn and the section is not created.
jihun kim @ on
The example I'm trying is 'x1_uh60_sopt_stf' which is created after installing iVABS.
An error message appears as shown in the attached picture.
It is assumed that the error occurs because VABS cannot be started because the first line, ln_af, is not drawn and the section is not created.
Any solution to this problem?
Reply Report abuse
bei li @ on
You can view your tmp file and find the corresponding line in the following figure
Reply Report abuse