Dear All, there are two channels for you to follow our research.
1. We started a newsletter called Thoughts on Composites Modeling on LinkedIn. Please subscribe to it to get informed about our research and ideas we want to share with the community.
2. We moved our discussion forum to github at wenbinyugroup · Discussions · GitHub as it has more features which can serve you better.
Wenbin
Anonymous @ on — Edited @ @ on
Dear Professor Yu,
How to set the length of the red line segment in the figure below, and whether the SG is established by shell element or solid element.
Cancel Report abuse
Ning Liu @ on — Edited @ @ on
Hi,
Did you upload a figure? I cannot see it from my side
Reply Report abuse
Anonymous @ on — Edited @ @ on
Sorry, I don't know why the picture didn't upload successfully.I tried again, but the picture still couldn't be uploaded successfully, so I had to add it in the attachment.
picture.docx
71 KBClick to download
Report abuse
Wenbin Yu @ on — Edited @ @ on
You can use Help->Report a problem to let our IT support folks to figure out the issue why the picture is not shown.
Reply Report abuse
feng liu @ on — Edited @ @ on
Thank you very much for your reply. I have fed back to the platform according to your method and am waiting for your reply. Can you see the attachment I uploaded? I look forward to your reply.
Report abuse
Ning Liu @ on
To answer your question, that 3D SG in your figure specifically is in solid element, the length does not matter, can be arbitrary (even zero).
With that being said, if the length of such 3D SG becomes zero, it is equivalent to a 2D SG (in shell element), which will give you the same constitutive relations (6x6 plate stiffness). Actually, the 2D SG is the fundamental building block, or a unit cell, that contains all the necessary information for constitutive modeling in this case, the length (your red line) is only required for 3D SG.
Consider here the 3D SG as an extrusion from 2D SG along your red line, nothing new.
However, the 2D SG only works when the stiffeners are uniform in the longitudinal direction, if a cross-type stiffeners are present (stiffeners are pointing both directions), then SG has to be in 3D.
Reply Report abuse
Wenbin Yu @ on
For 2D SG, you have 8 as homogenized SG volume
For 3D SG, you have 32 as homogenized SG volume.
Can you explain what are they?
Reply Report abuse
Wenbin Yu @ on
One thing I notice is that for your 3D SG, you have many aperiodic nodes in y2 direction, which is not correct. Try to make a periodic mesh to correct this mistake first.
Reply Report abuse
Ning Liu @ on
Make sure you output your y1-y2 -y3 as follows (y1 and y2 being periodic BC, y3 being the through-thickness direction), that way, SwiftComp should compute the right constitutive relations for you
Reply Report abuse
Anonymous @ on
Thank you very much for your reply. I'll practice again.
Report abuse