Dear All, there are two channels for you to follow our research.
1. We started a newsletter called Thoughts on Composites Modeling on LinkedIn. Please subscribe to it to get informed about our research and ideas we want to share with the community.
2. We moved our discussion forum to github at wenbinyugroup · Discussions · GitHub as it has more features which can serve you better.
Wenbin
Huijing Huijing Cao @ on — Edited @ @ on
Hi everyone,
I tried to run a case of a wind turbine blade section with 3 webs. There was a mistake on the meshing (screenshot.png). The relevant input files were attached. I would be much appreciated it if anyone can help me.
a cs with 3 webs
3 KBClick to download
Cancel Report abuse
Huijing Huijing Cao @ on — Edited @ @ on
screenshot.png
Reply Report abuse
Su Tian @ on
Hello Huijing,
To properly trim the web, the key point defining the web needs to be placed inside the 'surface' component. In your case, the point 'web_point_3' (0.89, 0) is located on the layup of the lower surface. After moving it to (0.89, 0.015), the web can be properly trimmed (see the figure).
Reply Report abuse
Huijing Huijing Cao @ on
OK. Thank you very much.
Report abuse